Owner's manual

Table 49 Voltage and current sensor locations
Sensor
Sensor Element Location
01.
Power Supply 1 +
5VDC
02.
Power Supply 1 +12 VDC
03.
Power Supply 2 +5 VDC
04.
Power Supply 2 +12 VDC
Use HP Command View EVA to view the voltage and current error thresholds for both +5 VDC and +12
VDC p ower supplies.
1.2.en.01 NONCRITICAL condition—High voltage
This conditi
on report indicates that a n element voltage is approaching, but has not reached, the high
voltage CRITICAL threshold. Continued operation under these conditions may result in a CRITICAL
condition. This condition report remains active until the problem is corrected.
To correct th
is problem, record a ll six characters of the condition report, then contact your HP authorized
service representative.
1.2.en.02 CRITICAL condition—High voltage
This condition report indicates that an element voltage has reached the high voltage CRITICAL threshold.
This report remain s active until the problem is corrected.
To correct this problem, record a ll six characters of the co ndition report, then contact your HP authorized
service representative.
1.2.en.03 NONCRITICAL condition—Low voltage
This condition report indicates that an element voltage is approaching, but has not reached, the low
voltage CR
ITICAL threshold. Continued operation under these conditions may result in a CRITICAL
condition. This condition report remains active until the problem is corrected.
To correct this problem, record a ll six characters of the co ndition report, then contact your HP authorized
service re
presentative.
1.2.en.04 CRITICAL condition—Low voltage
This condition report indicates that an element voltage has reached the low voltage CRITICAL threshold.
This condition report remains active until the problem is corrected.
To correct this problem, record a ll six characters of the co ndition report, then contact your HP authorized
service representative.
1.3.en.0
1 NONCRITICAL condition—High current
This condition report indicates that an element current is approaching, but has not reached, the high
current CRITICAL threshold. Continued operation under these conditions may result in a CRITICAL
conditi
on. This cond ition report remains active until the problem is corrected.
To correct this problem, record a ll six characters of the co ndition report, then contact your HP authorized
service representative.
1.3.en.02CRITICALcondition—Highcurrent
This condition report indicates that an element current has reached the high current CRITICAL threshold.
This condition report remains active until the problem is corrected.
138
EMU-generated condition reports