Owner's manual

To correct this problem, record all six characters of the condition report, then contact your HP authorized
service representative.
0.F.en.03 CRITICAL condition—Transceiver fibre channel drive enclosure bus fault
The system has detected a Fibre Channel drive enclosure bus fault involving a transceiver. This error
prevents the controller from transferring data on a loop and elim inates the enclosure dual-loop capability.
Complete the following procedure to c orrect this problem:
1. Record all six characters of the condition report.
2. Check all the
transceivers a nd cables to ensure they are properly connected.
3. Check all the transceivers o n the loop to ensure they are compatible with the I/O module.
4. If the problem persists, contact your HP authorized ser vice representative.
0.F.en.04CRITICALcondition—Transceiverremoved
The EMU detects that a transceiver has been removed. This error remains active until the problem is fixed.
Theerrorcanbeclearedbydoingoneofthefollowing:
1. Install a new transceiver,
or
Reconfigure the system by switching from a loop topology to one with Vixel sw itches, then the
transceiver is not necessary.
2. Clear the error by resetting the EMU or by removing and then re-installing the I/O module.
0.F.en.05 CRITICAL condition—Invalid fibre channel character
This sympto
m can occur under the following conditions:
• The incoming data stream is corrupted.
• A cable is not completely connected.
• The signal
is degraded.
This error
prevents the controller from transferring data on a loop and eliminates the enclosure du a l-lo o p
capabili
ty. Thiserrorremainsactiveuntiltheproblemisfixed.
To correct this problem, record all six characters of the condition report, then contact your HP authorized
service representative.
Voltage sensor and current sensor conditions
The format of these sensor condition reports is 1.2.en.ec for a voltage sensor, and 1.3.en.ec for a
current sensor, where:
• 1.2. is the voltage sensor element t ype
• 1.3. is the current sensor element type number
• en. is the sensor element number
• ec is the error code
Table 49 lists the location of the power supply voltage and current sensors.
4000/6000/8000 Enterprise Virtual Array user guide
137