Owner's manual

0.7.01.15 UNREC
OVERABLE condition—EMU hardware failure
The EMU has detected an internal hardware problem. This condition report remains active until the
problem is corrected.
Complete the fol
lowi ng procedure to correct this problem:
1. Record all six c
haracters of the condition report.
2. Reset the EMU.
3. Observe the EMU to ensure the error does not recur within the first minute.
4. If the error do
es recur, contact your H P authorized service representative. The EMU is inoperative
and must be replaced as soon as possible.
0.7.01.16 INFORMATION condition—EMU internal ESI data corrupted
The EMU ESI data is corrupted. This c ondition does not affect any other element and no action is require d.
0.7.01.17 UN
RECOVERABLE condition—Power shutdown failure
The power supply did not respond to a controller, EMU, or power supply shut down command. Shutting
down the supply is required to prevent overheating.
Complete the following procedure to correct the problem:
1. Record all six characters of the condition report.
2. Move the pow
er c ord bail lock 1, Figure 58,totheleft.
3. Disconnec
t the AC power cord 2 from the supply.
CXO7490
A
2
3
1
4
Figure 58 Disconnectin g AC power
0.7.01.18 UNRECOVERABLE condition—EMU hardwa re failure
The EMU has detected an internal hardware problem. This condition report remains active until the
problem is corrected.
Complete the following procedure to c orrect this problem:
1. Record all six characters of the condition report.
2. Reset the EMU.
3. Observe the EMU to ensure the error does not recur within the first minute.
4000/6000/8000 Enterprise Virtual Array user guide
135