Owner's manual

0.3.en.03 UNRECOVERABLE condition—Blower failure
A blower has stop
ped. The operational blower now operates a t high speed and is a single point of
failure. This c
ondition report remains active until the problem is corrected.
To correct this problem, record all six characters of the condition report, then contact your authorized
service representative.
0.3.en.04 UNRECOVERABLE condition—Blower internal
A p ower supply reported an internal blower error that could affect enclosure cooling and cause an
element to fail. H P recommends correcting the problem before the blower fails. This condition report
remains active until the p roblem is corrected.
To correct this problem, record all six characters of the condition report, then contact your HP authorized
service representative.
0.3.en.05 NONCRITICAL condition—Blower missing
A blower has been removed or is improperly installed. Even though the blower flaps close to maintain
the proper air flow, the reduced cooling capability can cause overheating, causing an element to fail.
This conditi
onreportremainsactiveuntiltheproblemiscorrected.
To correct this problem, record all six characters of the condition report, then contact your HP authorized
service representative.
0.3.en.06 UNRECOVERABLE condition—No blowers installed
NOTE:
IMPORTANT
When this condition exists there will be two error messages.
The first message will be
0.3.en.05 and will identify the first blower.
The second message will be
0.3.en.06 and will identify the second blower.
TheEMUcannotdetectanyinstalledblowers. Shutdown is imminent! The EMU will shut down the
enclosure in seven minutes unless you correct the p roblem. This co n dition report remains active u ntil you
correct the problem or the EMU shuts down the p ower supplies, whichever occurs first.
Complete the following procedure to c orrect this problem.
1. Record all six characters of the condition report.
2. Use the controller shutdown procedure to shut down the controllers.
3. Contact your authorized service representative.
CAUTION:
An automatic shutdown and possible data c orruption may result if the blower is removed before
a replacement is available.
Temperature conditions
The format of a temperature cond ition report is 0.4.en.ec,where:
• 0.4. is temperature sensor element type
• en. is the two-character temperature sensor element
• ec is the error code
4000/6000/8000 Enterprise Virtual Array user guide
129