Owner's manual

Class A equipme
nt
This equipment
has b een tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of th
eFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmful
interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction
s, may cause harmful interference to radio c ommunications. Operation of this equipment in a
residential a rea is likely to cause harmful interference, in which case the user will be required to correct
the interference at personal expense.
Class B equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are d esigned to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio com munications. However, there is no guarantee that interference will not occur in a particular
installation. If this equ ipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation bet ween the equipment and receiver.
• Connect the equipm ent into an outlet on a circuit that is different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or television technician for help.
Declaration of conformity for products marked with the FCC logo, United States only
This device complies with Par t 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Forquestionsregardingyourproduct,refertoh
ttp://thenew.hp.com.
For qu
estions regarding this FCC declaration, contact:
• Hewlett-Packard CompanyProduct Regulations Ma n ager3000 Hanover St.Palo Alto, CA 94304
• Or call 1-650-857- 1501
To id
entify this product, refer to the part, series, o r model number found on the p roduct.
Modifications
TheFCCrequirestheusertobenotified that a ny changes or modifications made to this device that are not
expressly approved by Hewlett-Packa rd Company may void the user’s authority to o perate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods
in or
der to m aintain compliance with FCC Rules and Regulations.
Laser device
All Hewlett-Packard systems equipped with a laser device comply with safety standards, including
International Electrotechnical Commission (IEC) 825. With specific regard to the laser, the equipment
complies with laser product performance standards set by government agencies as a Class 1 laser
product. The product does not emit hazardous light; the beam is totally enclosed during all modes of
customer operation and maintenance.
108
Regulatory notices and specifications