Owner's manual

A Regulatory n otices an d
spec ifications
This appendix includes regulatory notices and product specifications for the HP StorageWorks Enterprise
Virtual Array family.
The followi ng topics are included:
• Regulatory notices
• Fibre Channel drive enclosure specifications
• Fibre Channel switch specifications
• Controller specifications
• Rack specifications
Regulatory notices
Fe deral Communications Commission (FCC) notice
Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established Radio
Frequency (RF) emission limits to provide an interference-free radio frequency spectrum. Many electronic
devices, including computers, generate RF energy incidental to their intended function a nd are, therefore,
covered by these rules. These rules place computers and related peripheral devices into two classes, A
and B, d epending upon their intended installation. Class A devices are those that may reasonably be
expected to be installed in a business or commercial environment. Class B devices are those that may
reasonably be expected to be installed in a residential environment (for example, personal computers).
The FCC requires devices in both classes to bear a label indicating the interference potential of the device
as well as additional operating instructions for the user.
The rating label on the device shows the classification (A or B) of the equipment. Class B devices have an
FCC logo or FCC ID on the label. Class A devices do not h ave an FCC logo or FCC ID on the label.
After the class of the d evice is determined, refer to the c orresponding statement in the following sections.
FCC Class A certification
This eq
uipment generates, uses, and may emit radio frequency energy. The equipment has been type
tested
and found to comply with the limits for a Class A digital device pursuant to Part 15 of the F CC
rules,
which are designed to provide reasonable protection against such radio frequency interference.
Opera
tion of this equipment in a residential area may cause interference, in which case the user at the
user’s own expense will be required to take whatever measures may be required to correct the interference.
Any modi fications to this d evice—unless approved by the manufacturer—can void the user’s authority to
opera
te this equip m ent under Part 15 of the FCC rules.
NOTE:
Additional information on the need to interconnect the device with shielded (data) cables or the need for
special devices, such as ferrite beads on cables, is required if such means of interference suppression
was us
ed in the qualification test for the device. This information will vary from device to device and
needs to be obtained from the HP EMC group.
4000/6000/8000 Enterprise Virtual Array user guide
107