Owner's manual

0115a
3
2
1
Figure 48 Removing a disk drive
Changing the Device Addition Policy
To prevent the storage system from automatically grouping a new disk drive that may h ave the incorrect
firmware o n it, the Device Addition Policy must be checke d and set to manual if necessary:
1. In the Command View Navigation pane, select the storage system.
The Initialized Storage System Properties window opens.
2. Click System Options
3. Select Set system operational policies
4. IftheDeviceAdditionPolicyissettoAutomatic, change it to Manual
5. Click Save changes
Installing a disk drive
1. Push in the ejector push button on the disk drive and pull the release lever down to the full open
positio
n.
2. Insertthedriveintotheenclosureasfarasitwillgo(1,Figure 49).
3. Close the release lever until it engages the ejector push button, and the disk drive seats in the
backpla
ne (2).
4. Press in firmly on the disk drive to ensure it is seated properly.
0116a
2
1
Figure 49 Installing a disk drive
Veri
fying proper operation
Afte
r replacing the disk drive, check the following to verify that the d isk drive is o perating normally:
100
Customer replaceable units