Maintenance and Service Guide

Items Procedures
At this point, there should be sucient power from the AC adapter to the system
board. Expect to hear the fan spinning and see blinking lights or error messages (i.e.,
faulty memory, HDD, etc)
Verify Power Good (Troubleshooting) lights
1. Verify if the system board has power-on issue related. If there is no power-on
issue, move to next steps. For more information, see Power Good
(Troubleshooting) lights on page 97.
2. Verify all connections and reseat parts (10. Reseat cables and connections
on page 99).
Verify system board
1. Test essential hardware conguration (11. Test with minimum conguration
on page 100, 12. Test with veried working conguration (hardware and/or
operating system) on page 101, 13. Replace the system board on page 101) by
removing nonessential parts.
2. If there is still no boot, replace system board.
Tips and tricks Computer automatically boots without pressing power button when RTC 3V battery
has been removed. Therefore, after the service door and RTC 3V battery are removed,
no need to press power button from top side.
In essential hardware conguration, mWS G1 and G2 may require discrete GPU to boot.
However, mWS G3 can boot with integrated graphics.
See http://h20566.www2.hp.com/portal/site/hpsc/template.PAGE/action.process/
public/kb/docDisplay/?
javax.portlet.action=true&spf_p.tpst=kbDocDisplay&javax.portlet.begCacheTok=com.
vignette.cachetoken&spf_p.prp_kbDocDisplay=wsrp-interactionState%3DdocId
%253Demr_na-c01443371%257CdocLocale%253Den_US%257CcalledBy
%253D&javax.portlet.endCacheTok=com.vignette.cachetoken
Intermittent power-on, shutdown, reboot
Items Procedures
Symptoms
●
Does not always turn on
●
Intermittently hangs
●
Intermittently shuts down
●
Spontaneously reboots
Possible causes
Electrical short, uctuating power source, unstable power rails, loose connections, bent pins,
stray wires, dust, obvious damage, nearly faulty parts (bulging/leaking capacitor).
Potentially will turn into a no power issue soon (No Power on page 104).
Troubleshooting steps
1. Visually check power ports on both AC adapter and computer sides.
2. Inspect power sources:
a. Verify AC adapter working correctly. Use a conrmed working adapter to test.
b. Verify that battery is not depleted while system is in Sleep state. Test with a
conrmed working battery.
The sections below are intended for authorized service providers/technicians.
1. Follow actions in No Power on page 104.
106 Chapter 8 Troubleshooting guide