User's Manual

Table 7-1 Fax dialing settings (continued)
Menu item Description
Fax Send Speed The Fax Send Speed setting sets the modem bit rate (measured in bits per second) of
the Analog Fax modem while sending a fax.
● Fast (v.34 – 33.6k)
● Medium (v.17 – 14.4k)
● Slow (v.29 – 9.6k)
Line Monitor Volume Use the Line Monitor Volume setting to control the printer's dialing volume level when
sending faxes.
Dialing Mode The Dialing Mode setting sets the type of dialing that is used: either tone (touch-tone
phones) or pulse (rotary-dial phones).
Dialing Prex The Dialing Prex setting allows you to enter a prex number (such as a "9" to access
an outside line) when dialing. This prex number is automatically added to all phone
numbers when dialed.
Detect Dial Tone The Detect Dial Tone setting determines whether the fax checks for a dial tone before
sending a fax.
General fax send settings
Use the following steps to change the fax send settings.
1. From the Home screen on the printer control panel, navigate to the Settings application, and then select
the Settings icon.
2. Open the following menus:
a. Fax
b. Fax Send Settings
c. General Fax Send Settings
3. Congure any of the following settings, and then select Done.
Table
7-2 Fax send settings
Menu item Description
Fax Number Conrmation When the Fax Number Conrmation feature is enabled, the fax number must be
entered twice to ensure that it was entered correctly. The feature is disabled by
default.
PC Fax Send Use the PC Fax Send feature to send faxes from a PC. This feature is enabled by
default.
172 Chapter 7 Fax ENWW