User's Manual

12 2 Using the Monitor

Assigning the function buttons

Pressing one of the four front bezel function buttons activates the buttons and displays the icons

above the buttons. The factory default button icons and functions are shown below.

You can change the function buttons from their default values so that when the buttons are

activated you can quickly access commonly used menu items.

To assign the function buttons:

1. Press one of the four front bezel buttons to activate the buttons, and then press the Menu

button to open the OSD.

2. In the OSD menu, select Menu Control > Assign Buttons and then select one of the

available options for the button you want to assign.

NOTE: You can only assign the three function buttons. You can not reassign the Menu button or

the power button.

Using Auto-Sleep Mode

The monitor supports an OSD option called Auto-Sleep Mode that allows you to enable or

disable a reduced power state for the display. When Auto-Sleep Mode is enabled (enabled by

default), the monitor will enter a reduced power state when the host PC signals low power mode

(absence of either horizontal or vertical sync signal).

Upon entering this reduced power state (sleep mode), the monitor screen is blanked, the

backlight is turned off, and the power light indicator turns amber. The monitor draws less than

0.5 W of power when in this reduced power state. The monitor will wake from the sleep mode

when the host PC sends an active signal to the monitor (for example, if you activate the mouse

or keyboard).

You can disable Auto-Sleep Mode in the OSD. Press one of the four front bezel function buttons

to activate the buttons, and then press the Menu button to open the OSD.

1. In the OSD, select Power Control.

Button Function

1 Menu Opens the OSD (on-screen display) menu.

2 Information

(function button 1 -

assignable)

Opens the Information menu.

4 Viewing Mode

(function button 2 -

assignable)

Adjusts the monitor to a comfortable viewing light.

5 Next Active Input

(function button 3 -

assignable)

Switches the monitor’s input source to the next active

input.