User Manual

10 1 Getting Started
Mounting the display head
The display head can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.
If the monitor is TCO certified, the power cord plugged into the display head must be a shielded
power cable. The use of a shielded power cable meets the TCO Certified criteria for display
products. For information on TCO requirements, go to www.tcodevelopment.com.
CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach
a third-party mounting solution to the display head, four 4 mm, 0.7 pitch, and 10 mm long screws
are required. Longer screws must not be used because they may damage the display head. It is
important to verify that the manufacturer’s mounting solution is compliant with the VESA
standard and is rated to support the weight of the display head. For best performance, it is
important to use the power and video cables provided with the monitor.
Removing the monitor stand
You can remove the display head from the stand to install the display head on a wall, a swing
arm, or other mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure that the monitor is turned
off and all cables are disconnected.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a flat surface covered by a clean, dry cloth.
3. Remove the four screws from the VESA holes located on the rear of the display head.
Attaching the VESA mounting bracket
Install the mounting plate to the wall or swing arm of your choice using the four screws that were
removed from the VESA holes on the rear of the display head.