User's Manual
Table Of Contents
- HP 3PAR Storage Replication Adapter 5.5.2 for VMware® vCenter Site Recovery Manager™ User Guide
- Contents
- 1 Introduction
- 2 VMware vCenter Site Recovery Manager overview
- 3 Supported configurations
- 4 HP 3PAR SRA installation and configuration prerequisites
- 5 Installing HP 3PAR SRA
- 6 HP 3PAR storage system setup
- 7 Configuring VMware vCenter Site Recovery Manager and HP 3PAR SRA
- 8 Recovery and failback
- 9 HP 3PAR SRA for the VMware SRM 5.5 utility
- 10 Partial licensing
- 11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state diagram
- 12 Special notes
- 13 Support and other resources
- 14 Documentation feedback
The VMware vCenter Site Recovery Manager communicates with HP 3PAR Remote Copy Software
for storage replication through the HP 3PAR SRA. The HP 3PAR SRA provides information about
Remote Copy volume groups that exist in HP 3PAR StoreServ to Site Recovery Manager. The Site
Recovery Manager identifies datastores and RDM devices in the Remote Copy volume group (also
referred to as consistency groups). These datastores and RDM devices have corresponding virtual
volumes in the Remote Copy volume group and replicates between the protected site and the
recovery site.
6 VMware vCenter Site Recovery Manager overview