User's Manual
Table Of Contents
- HP 3PAR Storage Replication Adapter 5.5.2 for VMware® vCenter Site Recovery Manager™ User Guide
- Contents
- 1 Introduction
- 2 VMware vCenter Site Recovery Manager overview
- 3 Supported configurations
- 4 HP 3PAR SRA installation and configuration prerequisites
- 5 Installing HP 3PAR SRA
- 6 HP 3PAR storage system setup
- 7 Configuring VMware vCenter Site Recovery Manager and HP 3PAR SRA
- 8 Recovery and failback
- 9 HP 3PAR SRA for the VMware SRM 5.5 utility
- 10 Partial licensing
- 11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state diagram
- 12 Special notes
- 13 Support and other resources
- 14 Documentation feedback
11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state
diagram
Table 1 Remote Copy failover from Site A to Site B
Description
HP 3PAR OS
Command
Site B Role
after HP 3PAR
Site A Role
After HP
Execution
SiteSRM CommandState
System
Command
3PAR
System
Command
State 1–SecondaryPrimary——1
Check current group
status.
getvv
getvlun
SecondaryPrimaryBcheckFailoverFailover
1.1
getrcopy
Make sure all
changes are
getvv
getvlun
SecondaryPrimaryAsyncOnceFailover
1.2
replicated to the
remote site.
syncrcopy
Report replication
status.
getvv
getvlun
SecondaryPrimaryAquerySyncStatusFailover
1.3
getrcopy
Remove LUN
exposure from the
getvv
getvlun
SecondaryPrimaryAprepareFailoverFailover
1.4
host. Add Remote
getrcopy
Copy state to the
registry.
removevlun
Failover the Remote
Copy group to the
getvv
getvlun
Primary-RevPrimaryBfailoverFailover
1.5
target site. Add the
getrcopy
Remote Copy state
to the registry.
gethost
29