User's Manual
Table Of Contents
- HP 3PAR Storage Replication Adapter 5.5.2 for VMware® vCenter Site Recovery Manager™ User Guide
- Contents
- 1 Introduction
- 2 VMware vCenter Site Recovery Manager overview
- 3 Supported configurations
- 4 HP 3PAR SRA installation and configuration prerequisites
- 5 Installing HP 3PAR SRA
- 6 HP 3PAR storage system setup
- 7 Configuring VMware vCenter Site Recovery Manager and HP 3PAR SRA
- 8 Recovery and failback
- 9 HP 3PAR SRA for the VMware SRM 5.5 utility
- 10 Partial licensing
- 11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state diagram
- 12 Special notes
- 13 Support and other resources
- 14 Documentation feedback
between C—A and C—B are up, then SRA starts the remote replication from C—A and C—B and
waits till the sync is complete as part of the reprotect operation.
During the reprotect operation, SRA triggers delta resync operation from C—A and C—B where
C is the new primary system after failover. If the SRM recovery operation was performed when
either A—B or B—C or both the remote copy links are down, then as per the remote copy behavior,
reprotect operation triggered by SRM through SRA will initiate a full copy from C—B only (from
C—A, delta resync will be initiated).
25