User's Manual
Table Of Contents
- HP 3PAR Storage Replication Adapter 5.5.2 for VMware® vCenter Site Recovery Manager™ User Guide
- Contents
- 1 Introduction
- 2 VMware vCenter Site Recovery Manager overview
- 3 Supported configurations
- 4 HP 3PAR SRA installation and configuration prerequisites
- 5 Installing HP 3PAR SRA
- 6 HP 3PAR storage system setup
- 7 Configuring VMware vCenter Site Recovery Manager and HP 3PAR SRA
- 8 Recovery and failback
- 9 HP 3PAR SRA for the VMware SRM 5.5 utility
- 10 Partial licensing
- 11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state diagram
- 12 Special notes
- 13 Support and other resources
- 14 Documentation feedback
6 HP 3PAR storage system setup
Any HP 3PAR storage system acting as an array manager (at the protected site or at the recovery
site) in VMware vCenter Site Recovery Manager setup must be configured with HP 3PAR Remote
Copy Software.
HP 3PAR SRA supports synchronous and periodic replication modes in 1:1, 1:N, and N:1
configurations as supported by HP 3PAR remote copy, where N indicates the number of storage
arrays. HP 3PAR SRA also supports synchronous long distance configurations. For more information
about Remote Copy configurations, see the HP 3PAR Remote Copy Software User's Guide.
NOTE:
• An HP 3PAR Remote Copy Software license is required on the HP 3PAR StoreServ.
HP 3PAR SRA 5.5.2 supports SLD Remote Copy environment on HP 3PAR OS 3.1.2 MU3
P16 or later MUs and HP 3PAR OS 3.1.3 or later.
• HP 3PAR SRA supports mixed (RCIP – Async [Periodic] and RCFC – Sync) configuration.
NOTE: When using Peer Motion to perform data migration, the Remote Copy configurations
and SRM setup must be reestablished with the new array after migration. For more information
about re-establishing Remote Copy configurations, see the HP 3PAR Peer Motion Manager User
Guide or HP 3PAR Remote Copy Software User's Guide.
10 HP 3PAR storage system setup