User's Guide

HP 3PAR Online Import Utility createmigration Results in
“preparationfailed(-NA-)(OIUERRPREP1014: Error creating host on destination)”
Problem: Host already exists on destination HP 3PAR StoreServ Storage system with a different
WWN.
Solution: If the same host but different WWN: On initial migration of a host, all WWNs to be
included in storage group (even if not managing any LUNs). This way subsequent migration of
any WWN for this host will find a match. If a different host, change the host name so that it does
not match the existing hostname on destination HP 3PAR StoreServ Storage system.
HP 3PAR Online Import Utility createmigration ERROR: OIUERRCS1002.
Problem: Error occurs when the HP 3PAR Online Import Utility tries to verify a one-to-one zoning
between peer ports and source host ports. If there was no one-to-one mapping then HP 3PAR
Online Import Utility will return the error as shown below.
>createmigration -sourceuid 50060160BEA00351 -srchost R123-S02 -destcpg FC_r5 -destprov
full -migtype MDM
>ERROR: OIUERRCS1002 There is no one-to-one mapping between the peer ports and the
source host ports.
OIURSLCS1002 Ensure that there is a one-to-one mapping between the peer ports and the
source host ports, and that network connectivity between the host, source array and
destination array is proper.
Solution: Verify the source port on the fabric has been zoned with one peer port.
HP 3PAR Online Import Utility addsource ERROR: OIUERRDST0004.
Problem: This error occurs when the HP 3PAR Online Import Utility detects a destination HP 3PAR
storage system with firmware version earlier than the minimum.
The following figure shows a successful and an unsuccessful execution of the addsource operation.
The failure occurs because the HP 3PAR OS version is not supported.
Solution: Upgrade the HP 3PAR storage system to a supported version. See HP SPOCK for the
minimum supported version:
HP SPOCK (http://www.hp.com/storage/spock)
Troubleshooting Issues 97