User's Guide

Prerequisites
EMC SMI-S Provider is installed and operational.
The source EMC Storage system must be registered in the EMC SMI-S Provider application.
HP 3PAR Online Import Utility is installed and operational with network access to both the
EMC SMI-S Provider server managing the source storage system and the destination HP 3PAR
StoreServ Storage system.
Source EMC Storage system and destination HP 3PAR StoreServ Storage system are zoned
to each other.
Required Information
Source Storage System:
IP address of the EMC SMI-S Provider server that is managing the source EMC Storage system
from which the volumes are being migrated.
If the SMI-S server is managing more than one source EMC Storage system and you only
want to identify one of them you need to know the WWN of the source storage system.
User name and password for the EMC SMI-S Provider server.
Port to access EMC SMI-S Provider.
Secure port default 5989.
Non-secure port default 5988.
Destination HP 3PAR StoreServ Storage system:
IP address of the destination HP 3PAR StoreServ Storage system.
User name and password for the HP 3PAR management application with Super user permission.
Identifying the Source Storage System
To identify the source storage system, follow these steps:
1. From the HP 3PAR Online Import Utility, execute the addsource command.
NOTE: Use your local host user name and password credentials to log into the HP 3PAR
Online Import Utility.
Example 48 addsource command
>addsource -type VNX -mgmtip 10.10.10.10 -user admin -password adminpw -uid
xxxxxxxxxxxxxxxx
>SUCCESS: Added source storage system
2. Execute the showsource command to verify the source storage system information.
Example 49 showsource command
>showsource type VNX
NAME TYPE UNIQUE_ID FIRMWARE MANAGEMENT_SERVER OPERATIONAL_STATE
CLARiiON+APM00125345014 VNX 50067890BEE0177F 05.32.000.5.201 10.10.10.10 Good
Identifying the Destination Storage System
To identify the destination procedure, follow these steps:
Identifying the Source and Destination Storage Systems 67