User's Guide

Example 16 Using addsource to add a source storage system for online data migration
>addsource -type VMAX -mgmtip 10.10.10.10 -user admin -password adminpw -uid xxxxxxxxxxxxxxxx
>SUCCESS: Added source storage system.
>
>showsource
NAME TYPE UNIQUE_ID FIRMWARE MANA
GEMENT_SERVER OPERATIONAL_STATE
SYMMETRIX+000194901212 VMAX xxxxxxxxxxxxxxxx 5876.229.145
10.10.10.10 Good
3. Using the HP 3PAR Online Import Utility adddestination command, add the destination
HP 3PAR StoreServ Storage system.
Example 17 Using adddestination to add the destination storage system for online data
migration
>adddestination -type 3PAR -mgmtip 10.10.10.10 -user 3paradm -password 3parpassword
>SUCCESS: Added destination storage system.
>
>showdestination
NAME TYPE UNIQUE_ID FIRMWARE MANAGEMENT_SERVER OPER
ATIONAL_STATE PEER_PORTS
3par_7200_DCA_01 3PAR 2FF70002AC005F92 3.2.1 10.10.10.10 Norm
al 2022-0202-AC00-5F92(0:2:2) 2024-0202-AC00-5F92(0:2:4) 2122-0202-AC00-5F92(1:2:2) 2124-02
02-AC00-5F92(1:2:4)
4. Zone the host to the HP 3PAR StoreServ Storage system.
5. Configure native device-mapper multipath on the host:
a. If multipath is not already installed, install it.
b. Register HP 3PAR LUN types with native device-mapper-multipath by whitelisting HP
3PAR-specific information (in the /etc/multipath.conf file, the vendor is 3PARdata
and the product is VV). See the HP 3PAR StoreServ product documentation on the Linux
host configuration.
NOTE: 3PARdata and VV are case sensitive.
c. Register EMC LUN types with native device-mapper-multipath by whitelisting EMC source
array -specific information (if not previously configured).
d. Start native device-mapper-multipath.
e. Reload the multipath.conf file.
46 Performing Online Data Migration Using Linux