Owner manual

Programmieg Commands
This section describes the commands for programming with
the HP 38G. You can enter these commands in your program
by typing them or by accessing them from the Math menu.
1. Press ■ [PROGRAM] to open the Program catalog.
2. Press ({NEW}} or {{EDIT}} to open the Program editor.
The Program editor is
where you enter new
programs or edit existing
ones.
2. From the Program editor, press | math | {{CMDS}}.
Program —
categories
The HP 38G displays the Program Commands menu. The
left side of the screen shows the command categories
and the right side of the screen shows the available
commands.
rtviTi tm*» tusiWi—ft
COMMANDS
Rplet 1
Branch
Drawing
Graphic
CHECK
SELECT
ETVIEW
UNCHECK
Program
commands
Programming 8-9