Specifications

2-37
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 2 Device Management: Adding Clean Access Servers, Adding Filters
Integrating Cisco ISE Profiler
Figure 2-20 NAC Manager page on Cisco ISE
Step 2
In the NAC Managers page, click Add. The New NAC Manager page appears as shown in Figure 2-21.
Figure 2-21 Adding NAC Manager to ISE Profiler
Step 3
Enter the NAC Manager (CAM) details as follows:
• Name – Enter any descriptive name for the CAM.
• Description – Optionally, enter a description for the CAM.
• Status – Click the check box to enable communication from the Cisco ISE profiler that authenticates
connectivity to the CAM.
• IP Address – Enter the IP Address of the CAM. (For example, 255.255.255.255).
Note For High-Availability configurations, use the Service IP of the CAM. This allows failover
support of CAMs in High-Availability configuration.
Note Once saved, the IP Address of the CAM cannot be edited.