Specifications

2-32
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 2 Device Management: Adding Clean Access Servers, Adding Filters
Integrating Cisco ISE Profiler
Synchronize Endpoints from Cisco ISE Profiler
After configuring the ISE Profiler details in the CAM Web Console, CAM can synchronize all the
endpoints from ISE Profiler either automatically or manually by using the Sync Settings.
Step 1 Navigate to Device Management > Filters > Configuration > Profiler > Sync Settings.
Figure 2-15 Synchronizing the ISE Profiler
Step 2
Automatically sync starting from [] every [] hours – Enter the time at which the synchronization
should start in 24-hour format and enter the number of hours at which the synchronization should be
repeated.
Step 3 Click Update save the settings.
Step 4 Click Sync Now to start the synchronization manually.
Note When synchronizing automatically or manually, CAM deletes all the existing end-points in the CAM
Filter List and pulls all the end-points from ISE Profiler by applying the Rules (Matching Profiles)
configured in CAM.
You can click Check Sync Status Now to check the current synchronization status. This option displays
the following details: the last synchronized date and time, number of endpoints synchronized, and time
taken for synchronization.
Note While synchronizing, NAC searches for the Primary Profiler. If it is not reachable, then it searches for
the Secondary Profilers, one by one in the List. You should have already selected one of the Profilers in
the List as “Primary.”