Specifications

14-45
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 14 Administering the CAM
Support Logs
For details on the Event Log, see Chapter 13, “Monitoring Event Logs.”
Filtering Logs by CAS and/or Agent IP
Starting from Cisco NAC Appliance Release 4.9, you can filter the CAM Logs by CAS and/or Agent
machine by specifying the IP Addresses. If the CAS in HA setup, then the service IP and eth0 addresses
of both Active and Standby CAS should be entered for the filtering to happen properly.
Under Filter by (Change log level for) CAS/Agent IP Address, enter the following:
• CAS IP Address: Enter the IP Address of the specific CAS.
• Agent IP Address: Enter the IP Address of the specific client machine.
Note You can enter more than one IP Address by separating them with a comma. You can include the range
of IP Addresses as well. For example, you can enter the IP Address as 10.10.10.10,10.10.10.15-20.
• Log at Level: Choose the log level.
Note To enable the Filter by CAS / Agent option, set the log levels of all the other categories to OFF.
Click Update Filter to save the settings. Download support logs to view information related to the
specified CAS and Agent. To store all events to the nac_manager.log file, enable Store all the events
to log file checkbox in the Monitoring > Event Logs > Log Settings page. This option is disabled by
default. Refer to Limiting the Number of Logged Events, page 13-9.
Figure 14-31 shows an example of the Log file.
Figure 14-31 NAC Manager Logs