Specifications

13-15
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 13 Monitoring Event Logs
SNMP
Add New Trapsink
The Clean Access Manager can be configured to send traps by adding trap sinks. All traps sent are
version 1 (v1) traps. A copy of each trap will be sent to each trapsink.
Step 1 Click the Add New Trapsink link in the upper-right-hand corner of the pane to bring up the Add New
Trapsink form as shown in Figure 13-5.
Figure 13-5 Add New Trapsink
Step 2
Enter a Trapsink IP.
Step 3 Enter a Trapsink Community string.
Step 4 Enter an optional Trapsink Description.
Step 5 Click Update to update the SNMP Trapsink table.
Once trapsink configuration is complete, the Clean Access Manager will send DISMAN-EVENT style
traps which refer to UCD table entries. The Clean Access Manager also sends traps if the root partition
falls below a configured amount of space remaining (which defaults to 50%), and if the CPU load is
above the configured amount for 1, 5 or 15 minutes.