Specifications

12-17
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 12 Configuring Network Scanning
View Scan Reports
Show Log
Clicking the Show Scan Log button on the Device Management > Network Scanner > Scan Setup >
Test page brings up a debug log (Figure 12-12) for the target computer tested (sourced from
/var/nessus/logs/nessusd.messages). The log shows which plugins were executed, the results of the
execution, which plugins were skipped and the reason (dependency, timeout, etc). Administrators can
check this log to debug why a scan result is not as expected.
Figure 12-12 Network Scanning Show Log
View Scan Reports
After enabling network scanning, you can view individual scan reports from Device Management >
Clean Access > Network Scanner > Reports. The report shown here is the full administrator report
(Figure 12-14). The report shown to end users contains only the vulnerability results for the enabled
plugins. (Users can access their version of the scan report by clicking the Scan Report link in their
Logout page.)