Specifications

12-12
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 12 Configuring Network Scanning
Configure Plugin Options
Note If the plugin is dependent on other plugins in the repository, those plugins are enabled automatically.
6. When finished, click Update. This transfers the selected plugins to the Vulnerabilities page so that
you can configure how these vulnerabilities are handled if discovered on a client system.
If the plugin has configurable parameters, you can now use the Options form to configure them, as
described in the following procedures. Otherwise you can continue to Configure Vulnerability Handling,
page 12-13.
Configure Plugin Options
For plugins that support input parameters, you can configure parameters in the Options form. Before
starting, the plugin must be enabled in the Plugins form, as described in Apply Plugins, page 12-10.
To configure plugin options:
1. In the Network Scanner tab, click the Scan Setup submenu link, then open the Options form.
2. With the appropriate role and operating system selected, choose the plugin you want to configure
from the Plugin list. All plugins enabled for the role appear in the list.
3. Choose the option you want to configure for the plugin from the options list. When you select a
configurable option, Category, Preference Name, and Preference Value dropdowns and/or text
boxes will display, as applicable for the option. Parameters that cannot be configured are indicated
by a “Not supported” message.
Figure 12-8 Options
4.
From the dropdown menus, select the Category and Preference Name, type the Preference Value
(if applicable), and click Update. Note that you need to click Update for each parameter you
configure.