Specifications

12-8
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 12 Configuring Network Scanning
Load Nessus Plugins into the Clean Access Manager Repository
Figure 12-4 Plugins Page After Upload
Note The default view on the Plugins page is “Selected.” If Nessus plugins have not yet been checked
and updated for the user role, the default view (i.e. Selected Plugins) shows no plugins. To view
the plugins you have uploaded, choose one of the other views (for example, “All,” “Backdoors,”
etc.) from the “Show...Plugins” dropdown.
5. If the plugins do not immediately display after Upload, click Delete All Plugins, then perform the
upload again.
6. Apply the plugin and configure its parameters as described in the following sections:
– Apply Plugins, page 12-10
– Configure Vulnerability Handling, page 12-13.
Note When there are plugin dependencies and a prerequisite plugin is not uploaded, the uploaded
plugin will not be applied.
Deleting Plugins
1. Go to Device Management > Clean Access > Network Scanner > Plugin Updates.
2. Click the Delete All Plugins button to remove all plugins from the repository. The Network
Scanner > Scan Setup > Plugins page will no longer be populated.