Specifications

4-23
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 4 Wireless LAN Controller Management: Configuring Wireless Out-of-Band Deployment
Configure Wireless LAN Controller Connection on the CAM
Step 3 Choose a Device Group from the dropdown.
Step 4 Choose a Default Port Profile from the dropdown.
Step 5 Type a valid IP Address in the text box.
Step 6 Choose the Control Method to configure the SNMP trap notification type that the CAM SNMP Receiver
will use for a particular switch.
Note The Control Method is applicable only for the switches.
MAC Notification—If a switch supports MAC Notification, choose this option.
Note To support a variety of switch configurations, Cisco NAC Appliance supports switches using
both MAC Change Notification and MAC Move Notification traps.
Linkup Notification—If a switch does not support MAC Notification, then choose this option.
Step 7 Click Veri fy.
The device is verified and the results are displayed at the bottom of the page as shown in Figure 4-19.
Figure 4-19 Verify Devices - Result
The device status is displayed and you can select a connected port that you would like to bounce from
the dropdown.