Specifications

4-12
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 4 Wireless LAN Controller Management: Configuring Wireless Out-of-Band Deployment
Configure Your Wireless LAN Controllers
Figure 4-6 SNMP Trap Receivers > New Page
Step 2 Specify the host name of the CAM to receive SNMP traps from the WLC in the Trap Receiver Name
field.
Step 3 Enter the CAM’s IP address in the IP Address field.
Step 4 Choose Enable from the Status dropdown menu.
Step 5 Click Apply to commit your changes.
Step 6 Click Save Configuration to save your settings.
Wireless OOB Network Setup/Configuration Worksheet
Table 4-3 summarizes information needed to configure WLCs and the Clean Access Manager.
Table 4-3 Configuration Worksheet
Configuration Settings Value
Wireless LAN Controller Configuration
WLC IP Address/Netmask:
New dynamic interface
SSID Access VLAN:
SSID Authentication (Quarantine) VLAN:
SNMP version used
SNMP (V1/V2c) read community name:
SNMP (V1/V2c) write community name:
SNMP (V3) auth method/username/password:
SNMP Trap V2c community string (to send traps to CAM):
CAM/CAS Configuration
CAM host name
CAM IP address:
CAS Trusted IP address:
CAS Untrusted IP address:
CAM SNMP Trap Receiver
Community name for SNMP Trap V1 devices: