Specifications

4-9
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 4 Wireless LAN Controller Management: Configuring Wireless Out-of-Band Deployment
Configure Your Wireless LAN Controllers
Figure 4-3 WLC 4400 Interfaces > Edit Page
Step 4
Configure the following parameters:
• Guest LAN
• Enable the Quarantine option and specify a quarantine Quarantine VLAN ID.
Note Check the Quarantine check box if you want to configure this VLAN as unhealthy or you want
to configure network access control (NAC) Out-of-Band integration. Doing so causes the data
traffic of any client that is assigned to this VLAN to pass through the controller.
• Physical port assignment
• VLAN identifier
• Fixed IP address, IP netmask, and default gateway
• Primary and secondary DHCP servers
• Access control list (ACL) name, if required
Note To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
Step 5 Click Save Configuration to save your changes.
Step 6 Repeat this procedure for each dynamic interface that you want to create or edit.
For more information, refer to the Cisco Wireless LAN Controller Configuration Guide, Release 5.1.
Create the WLAN on the Wireless LAN Controller and Enable Cisco NAC Appliance Integration
To create a new WLAN on the Wireless LAN Controller and enable integration with Cisco NAC
Appliance: