Specifications

3-66
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Figure 3-39 Enabling Port Security from the CAM
Note • Port Security can only be enabled on a port set to Access mode (i.e not Trunk mode).
• The MAC address(es) connected to a particular port may not be available after Port Security is
enabled. This occurs on some models of Cisco switches (e.g. 4507R, IOS Version 12.2(18) EW).
• If implementing High-Availability, ensure that Port Security is not enabled on the switch interfaces
to which the CAS and CAM are connected. This can interfere with CAS HA and DHCP delivery.
Re-Enabling MAC Notification
Step 1 Go to OOB Management > Devices > List and click the Config icon for the switch you want to control.
Step 2 From the Config tab, click the Advanced link.
Step 3 Click the option for Mac Notification.
Step 4 Click Update.
Step 5 A prompt (Figure 3-40) displays the following message “The running configuration of this switch needs
to be updated. Do you want to update the switch running configuration?”
• If you click OK, the running configuration is updated on the switch.
• If you click Cancel, you will need to reconfigure the controlled ports on the Ports page, as described
Manage Individual Ports (MAC Notification), page 3-55.
Figure 3-40 Reverting to MAC Notification from the CAM