Specifications

3-63
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Config Tab
The Config tab allows you to modify Basic, Advanced, and Group profile settings for a particular switch:
• Basic
• Advanced
• Group
Basic
The Basic tab (Figure 3-37) shows the following values configured for the switch.
Figure 3-37 Basic Config
• The first values come from the initial configuration done on the switch itself:
– IP Address
– MAC Address
– Location
– Contact
– System Info (translated from the MIB for the switch)
• Device Profile—Shows the Device Profile you are using for this switch configured under OOB
Management > Profiles > Device. The Device Profile sets the model type, the SNMP port on which
to send SNMP traps, SNMP version for read and write and corresponding community strings, or
authentication parameters (SNMP V3 Read and Write).
• Default Port Profile—Shows the default Port profile applied to unconfigured ports on the switch
on the Ports tab. The “uncontrolled” port profile is the initial default profile for all ports, unless you
change the setting here. You can change the Default Port Profile by selecting another profile from
the dropdown menu and clicking Update.