Specifications

3-56
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Step 5 Click Setup ( •Setup button (MAC notification switches only) (5), page 3-56) to initialize MAC change
notification/MAC move notification on switch ports (if available on the switch).
Step 6 Click Save ( •Save (6), page 3-57) to save the switch running configuration to the switch stored (startup)
configuration.
• Unmanage All
Click Unmanage All to change all the managed ports to default port profile that was setup for the
switch.
• Reset All (Initial VLAN Port Profiles only)
Clicking Reset All copies the switch’s Current VLAN values ( •Current VLAN, page 3-59) for all
ports and sets these as the Initial VLAN settings (for access ports) and trunk native VLAN settings
(for trunk ports) ( •Initial VLAN (Initial VLAN Port Profiles only), page 3-58) on the CAM and on
the running configuration of the switch. This button allows you to change the Initial VLAN for all
ports at the same time on the switch. Click OK in the confirmation to reset the values:
• Set New Ports (Initial VLAN Port Profiles only)
Clicking Set New Ports (Figure 3-34) preserves settings for existing ports, but copies the switch’s
Current VLAN values for new ports and sets these as Initial VLAN settings (for access ports) and
trunk native VLAN settings (for trunk ports) on the CAM and on the switch running configuration.
This is useful when new ports are added to a switch, such as when adding a new blade in a Catalyst
4500 series rack. In this case, when the new ports are added, the Initial VLAN column displays
“N/A.” Clicking Set New Ports copies the values from Current VLAN column to the Initial VLAN
column for all “N/A” ports and sets these values on the CAM and switch. The Initial VLAN values
for existing ports on the switch (i.e. not “N/A”) will not change. Click OK in the confirmation to set
the new values.
• Setup button (MAC notification switches only) (5)
For switches that support MAC change notification/MAC move notification traps, click the Setup
button after updating the CAM to set up MAC notification on managed switch ports and save the
running configuration of the switch. Click OK to initialize ports on the switch.