Specifications

3-53
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Note An entry must exist in the Wired Clients list in order for the CAM to determine the switch port for which
to change the VLAN. If the user is logging in at the same time that an entry in the Wired Clients list is
deleted, the CAM will not be able to detect the switch port.
Figure 3-33 Discovered Clients
Elements of the page are as follows:
• Show clients connected to switch with IP—Leave the default of ALL switches displayed, or
choose a specific switch from the dropdown menu. The dropdown menu displays all managed
switches in the system.
• Show client with MAC—Type a specific MAC address and press Enter to display a particular client.
• Clients/Page—Leave the default of 25 entries displayed per page, or choose from the dropdown
menu to displays 50, 100, 200, or ALL entries on the page.
• Delete All Clients—This button removes all clients on the list.
• Delete Selected—This button only removes the clients selected in the check column to the far right
of the page.
• Note that you can click any of the following column headings to sort results by that column:
– MAC—MAC address of discovered client
– IP—IP address of the client
– Switch—IP of the originating managed switch. Clicking the IP address brings up the OOB
Management > Devices > Switch [IP] > Config > Basic page for the switch.
– Switch Port—Switch port of the client. Clicking the port number brings up the OOB
Management > Devices > Switch [IP] > Ports configuration page for the switch.
– Auth VLAN—Authentication (quarantine) VLAN
A value of “N/A” in this column indicates that either the port is unmanaged or the VLAN ID
for this MAC address is unavailable from the switch.