Specifications

3-51
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Note While all switches matching the read community string of the Switch Profile used for the search are
listed, only those switches matching the read SNMP version and community string can be added using
the Commit button. A switch cannot be controlled unless its write SNMP settings match those
configured for its Switch Profile in the Clean Access Manager.
Step 8 Click the Commit button to add the new switches. These switches are listed under OOB Management
> Devices > Devices > List.
Verify Devices
The Ve r ify page allows you to verify the devices. This utility verifies a device already added to CAM or
a new device that is yet to be added to CAM. The device may be a switch or WLC.
Note Before verifying a device, ensure that you have setup the device profile and port profile, and configured
the SNMP receiver for the device.
Step 1 Go to OOB Management > Devices > Devices > Verify.
Figure 3-31 Verify Devices
Step 2
Choose a Device Profile from the dropdown.
Step 3 Choose a Device Group from the dropdown.
Step 4 Choose a Default Port Profile from the dropdown.
Step 5 Type a valid IP Address in the text box.
Step 6 Choose the Control Method to configure the SNMP trap notification type that the CAM SNMP Receiver
will use for a particular switch.
Note The Control Method is applicable only for the switches.