Specifications

3-49
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
• Delete—Clicking the Delete icon deletes the switch from the list (a confirmation dialog will appear
first).
Note When adding a switch based on its loopback address, the OOB Management > Devices > Devices >
List will display a MAC address of 00:00:00:00:00:00 for the switch. This is expected behavior; the
MAC address displayed on this interface is for information only and does affect OOB functionality.
Add New Switch
The New page allows you to add switches when exact IP addresses are already known.
Note Cisco does not support third party devices. If a non-Cisco or a custom device (third party device) is added
to NAC, then a message is displayed that the device being added is a non-Cisco device and support for
non-Cisco devices is not guaranteed.
Step 1 Go to OOB Management > Devices > Devices > New (Figure 3-29).
Figure 3-29 Add New Switch
Step 2
Choose the Device Profile from the dropdown menu to apply to the switches or WLCs to be added.
Step 3 Choose the Device Group for the switches or WLCs from the dropdown menu.
Step 4 Choose the Default Port Profile from the dropdown menu. Typically, the default port profile should be
uncontrolled.
Step 5 Type the IP Addresses of the switch(es) you want to add. Separate each IP address by line.
Step 6 Enter an optional Description of the new switch.
Step 7 Click the Add button to add the switch or WLC.