Specifications

3-45
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Figure 3-26 CAM SNMP Receiver
Step 2 Use the default Trap Port on Clean Access Manager (162) or enter a new port number here.
Step 3 For SNMP V1 Settings, type the Community String used on switches using SNMP V1.
Step 4 For SNMP V2c Settings, type the Community String used on switches using SNMP V2c.
Step 5 For SNMP V3 Settings, configure the following fields used on switches using SNMP V3:
• Specify the SNMP V3 authentication and privacy combination using the Security Method
(Auth/Priv) dropdown menus:
– NoAuth, MD5 (non-FIPS only), SHA-1
– NoPriv, DES (non-FIPS only), 3DES
Note If you are specifying an authentication/privacy combination for a FIPS 140-2 compliant
CAM, the only settings available are the SHA-1 authentication and 3DES privacy types.
• Type the User Name.
• Type the User Auth.
• Type the User Priv
Step 6 Click Update to save settings.
Advanced Settings
This page configures advanced timeout and delay settings for the SNMP traps received and sent by the
Clean Access Manager (CAM). To change the default settings, use the following steps. You can use the
page to fine-tune settings from their defaults once switches are added and configured.