Specifications

3-30
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure OOB Switch Management on the CAM
Figure 3-13 Edit Group
Step 3 You can toggle the switches that belong in the Group profile by selecting the IP address of the switch
from the Member Switches or Available Switches columns and clicking the Join or Remove buttons
as applicable.
Step 4 Click the Update button when done to save your changes.
Note To delete a group profile, you must first remove the joined switches from the profile.
Configure Switch Profiles
A Switch profile must first be created under OOB Management > Profiles > Device > New, then applied
when a new switch is added. A Switch profile classifies switches of the same model and SNMP settings,
as shown in Figure 3-14. The Switch profile configures how the CAM will read/write/change port
settings, such as Access/Auth VLAN, on a switch of this particular type.
Figure 3-14 Switch Profiles List