Specifications

3-18
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 3 Switch Management: Configuring Out-of-Band Deployment
Configure Your Switches
For auth (SNMP username/password is “cam_user”/“cam_auth”)
(config)# snmp-server group cam_group v3 auth read v1default write v1default notify
v1default
(config)# snmp-server user cam_user cam_group v3 auth md5 cam_auth
(config)# snmp-server host 172.16.1.61 traps version 3 auth cam_user udp-port 162
mac-notification snmp
For priv (SNMP username/password is “cam_user”/“cam_priv”)
(config)# snmp-server group cam_group v3 priv read v1default write v1default notify
v1default
(config)# snmp-server user cam_user cam_group v3 auth md5 cam_auth priv des cam_priv
(config)# snmp-server host 172.16.1.61 traps version 3 priv cam_user udp-port 162
mac-notification snmp
Step 10 Enable the Port Fast command to bring a port more quickly to a Spanning Tree Protocol (STP)
forwarding state. You can do this at the switch configuration level for all interfaces, or at the interface
configuration level for each interface:
• Switch configuration level:
(config)# spanning-tree portfast default
• Interface configuration level:
(config-if)# spanning-tree portfast
Figure 3-5 illustrates an example OOB setup.