User guide

40 Chapter 2 - Operation EN
Canceled Send.
Clear Document
The cancel key was pressed to
cancel the current job while
pages were feeding from the
document feeder. The cancel
process will not automatically
clear the document feeder.
Pull the document release door
open, remove the jammed item,
and close the door. Then, clear
the items in the document feeder
tray and start over.
CCD Scanner Error
The scanner assembly
experienced an internal error.
Disconnect the power cable from
the product, wait at least 30
seconds, then reconnect the
power cable and wait for the
product to initialize. Try another
power source. If the message
does not clear, see chapter 6,
“Troubleshooting.”
Comm. Error
Fax communication error
occurred between the product
and the sender or receiver.
Allow the product to retry sending
the fax.
Unplug the product telephone
cord from the wall, plug in a
telephone, and try making a call.
Plug the product phone cord into
a jack for another phone line.
See chapter 6,
“Troubleshooting.”
Device Busy.
Try Again Later
The product is currently in use. Wait for the product to finish the
current job.
Device Error.
[Enter] To Cont.
There was an internal error in the
product.
Press menu/enter to resume the
job.
Doc Feeder Jam
A piece of media is jammed in
the document feeder tray.
Open the document release
door, clear the jam, close the
document release door, and
reload the paper into the
document feeder tray.
Document Feeder
Mispick. Reload
Media in the document feeder
tray was not picked up.
Remove and reload the media
into the document feeder tray.
Door Open Or No
Print Cartridge
The print cartridge door is open
or the print cartridge is not
installed properly.
Make sure the print cartridge
door is closed. Check the print
cartridge for proper installation.
Engine Comm. Error
The product experienced an
internal communication error.
Warning message only. Job
output may be affected.
Table 10. Control panel error messages (continued)
Message Cause Solution