Service manual

Notice

0Notice

The information in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this material, including,

but not limited to, the implied warranties of merchantability and fitness for a particular

purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental

or consequential damages in connection with the furnishing, performance, or use of this

material.

This document contains or refers to proprietary information which is protected by

reproduced, or translated to another language without the prior written consent of Hewlett-

Packard Company.

Responsibility of the Manufacturer

Hewlett-Packard only considers itself responsible for any effects on safety, reliability and

performance of the equipment if all the following are true:

• Assembly operations, extensions, re-adjustments, modifications or repairs are done by

persons authorized by Hewlett-Packard.

• The electrical installation of the relevant room complies with the IEC or national require-

ments.

• The instrument is used according to the instructions for use presented in this manual.

As with all electronic equipment, radio frequency interference between this

cardiograph and any existing RF transmitting or receiving equipment at the

installation site, including electrosurgical equipment, should be evaluated

carefully and any limitations noted before the equipment is placed in service.

Monitoring during electrosurgery should not be attempted and monitoring

electrodes should be removed from the patient to preclude the possibility of

burns. Radio frequency generation from electrosurgical equipment and close

proximity transmitters may seriously degrade cardiograph performance. Hewlett-

Packard assumes no liability for failures resulting from RF interference between

HP medical electronics and any radio frequency generating equipment at levels

exceeding those established by applicable standards.

WARNING