Service manual

The Storage and Transmission Board Assembly
5-24
4. When the storage and transmission board assembly has been pried out at least 0.25
inches, it should slide out freely.
5. Install the new storage and transmission board assembly by sliding it between the
guides in the expansion slot. Be sure the assembly is aligned between the guides.
6. The board assembly should slide freely until the last 0.25 inches.
7. Press firmly on the board assembly bracket to mate the assembly with the connector
inside the cardiograph. The face of the bracket should now be nearly flush with the
cardiograph case.
8. Install the two screws at the right and left side of the bracket using a T-10 screwdriver.