Manual

Entering the WWN
Fibre Channel protocol requires that each controller pair have a unique WWN. This 16-character
alphanumeric name identifies the controller pair on the storage system. Two WWN labels attached to the
rack identify the storage system WWN and checksum. See Figure 4.
NOTE:
• TheWWNisuniquetoacontrollerpairandcannotbeusedforanyothercontrollerpairordevice
anywhere on the network.
• This is the onl
y WWN applicable to any controller installed in a specificphysicallocation,evena
replacement controller.
• Once a WWN is assigned to a controller, you cannot change the WWN while the controller is part
of the same storage system.
CXO7601
C
Figure 4 Location of the World Wide Name labels
Complete the following procedure to assign the WWN to each pair of controllers.
1. Turn the power switches on bo th controllers off.
2. Apply power to the rack.
3. Turn the power switch on b oth controllers on.
NOTE:
Notifications of the startup test steps that have been executed are displayed while the
controller is booting. It may take up to two minutes for the steps to display. The default
WWN entry display has a 0 in each of the 16 p ositions.
4. Press or until the first character of the WWN is displayed. Press to accept this character
and select the next.
5. Repeat the preceding step to enter the remaining characters.
6. Press
t
o accept the WWN and select the checksum entr y mode.
Entering the WWN checksum
The second part of the WW N entry procedure is to enter the t wo-character checksum, as follows.
1. Verify that the initial WWN checksum displays 0 in both positions.
2. Press
or until the first checksum character is displayed. Press to accep t this character and
select the second character.
3. Press
or until the second character is displayed. Press to a ccept the checksum and exit.
4. Verify that the default display is automatically selected. This indicates that the checksum is valid.
Enterprise Virtual Array 3000/5000 user guide
27