Instruction Manual

Description
Message
Number
Log messageID
An iSCSI initiator logged into a router
presented target.
1435
QLIS_OpenConnectionNotification: Tar-
get connection opened (Port %d, DDB
%d)
54683
Event notification: iSCSI open connection
request.
1690
QLIS_HandleTeb:
UTM_EC_OPEN_CONNECTION
54938
Event notification: iSCSI close connection
request or connection closed.
1691
QLIS_HandleTeb:
UTM_EC_CLOSE_CONNECTION or
UTM_EC_CONNECTION_CLOSED
54939
Event notification: iSCSI connection opened1692
QLIS_HandleTeb: UTM_EC_CONNEC-
TION_OPENED
54940
Event notification: connection opened with
iSNS server.
1693
QLIS_HandleTeb:iSNS Server Open
Connection succeeded
54941
Event notification: iSNS SCN received.1695QLIS_HandleTeb: UTM_EC_ISNS_SCN54943
Event notification: iSNS client discovered.1697
QLIS_HandleTeb: UTM_EC_ISNS_CLI-
ENT_DISCOVERED
54945
iSCSI driver
The following log messages are common to both iSCSI ports, 1 (GE1) and 2 (GE2). They are listed
in Table 22 and described in this section. Log messages beginning with #0 apply to iSCSI port 1
(GE1), and log messages beginning with #1 apply to iSCSI port 2 (GE2).
Table 22 SCSI driver—informational log messages
Description
Message
Number
Log messageID
iSCSI port enabled, port up.327#%d: QLPortUp: Set link configuration 0x%x86343
Restart iSCSI processor (RISC).331#%d: QLDisable: Restart RISC86347
EEPROM updated, restart iSCSI
processor (RISC).
333
#%d: QLEnable: Restart RISC to update EEP-
ROM
86349
iSCSI port disabled, port down.336#%d: QLPortDown: Set link configuration 0x%x86352
Linkup reported by iSCSI processor
for GE1 or GE2.
858#%d: QLIsrDecodeMailbox: Link up86874
iSCSI port link-up at 100Mb full-
duplex
1330#%d: QLGetFwStateCallback: link 100Mb FDX87346
iSCSI port link-up at 100Mb half-
duplex
1331#%d: QLGetFwStateCallback: link 100Mb HDX87347
iSCSI port link-up at 1000Mb full-
duplex
1332#%d: QLGetFwStateCallback: link 1000Mb FDX87348
iSCSI port link-up at 1000Mb half-
duplex
1333
#%d: QLGetFwStateCallback: link 1000Mb
HDX
87349
Log data180