Instruction Manual

Figure 15 Disk drive activity indicator
Creating disk groups
The new disks you add will typically be used to create new disk groups. Although you cannot select
which disks will be part of a disk group, you can control this by building the disk g roups sequentially.
Add the disk drives required for the first disk group, and then create a disk group using these disk drives.
Now add the d isk drives for the second disk group, and then create that disk group. This process gives
you contr
ol over which disk drives are included in each disk group. Figure 16 shows the sequential
building
of vertical disk groups.
NOTE:
Standard and FATA disk drives must be in separate disk groups. Disk drives of different capacities and
spindle speeds can be included in the same disk group, but you may want to consider separating
them int
oseparatediskgroups.
Enterprise Virtual Array 3000/5000 user guide (VCS 3.110)
53