Instruction Manual

NOTE:
If one or more of the disk drives inserted does not reach the solid green indication after
70 seconds, remove the drive or drives and check for damaged connectors on the disk
drive and drive enclosure.
If no damage is found, repeat Steps 1 and 2. After two at tempts, replace drives that do
not reach the solid green indication. When all of the inserted disk dri ves successfully
reach the solid green indication, then repeat Steps 1 and 2 for the next set of 1 to 4 disk
drives to be inserted.
NOTE:
Drive insertion refers to physically inserting drives into drive enclosure slots. It is not
synonymous with drive addition to a disk group.
How to install a drive blank
Complete the following procedure to replace a disk drive with a drive blank:
1. Push in the disk drive port wine-colored Ejector Button 1 (see Figure 6 9) and pivot the Release Lever
2tothefull,openposition.
CXO6826
A
1
2
Figure 69 Removing a drive to install a drive blank
2. Pull on the drive to disconnect from the backplane connector.
CAUTION:
The carrier can be dropped due to the rapidly rotating media. To prevent equipment
failure, remove the carrier from the enclosure when the media has stopped rotating. This
takes approx imately 30 seconds.
3. When you are sure that the media is no longer spinning, remove the drive from the enclosure.
4. Insert the drive blank (see Figure 70)intotheenclosurebay until t he locking tabs engage the
enclosure.
162
Customer replaceable units