Installation manual

Diagnostic Executive
The Diagnostic Executive (Exec) provides a single, unified diagnostic environment with one user
interface. The diagnostic tests reside in individual programs that work through the Exec platform. The
platform provides a consistent interface and multitasking capabilities. Some features are:
Multiple Consoles
The Exec can run from any control terminal. This may be a monitor, serial port, or a remote
console.
Error Logging
The Exec provides the ability to capture error messages into a logfile. The logfile may reside on
a local disk or on a server.
Script Execution
Command scripts can be used to drive the menus without further user input.
Remote Execution
The Exec has the ability to perform remote diagnostics over a modem connected to a Serial Port
or over Ethernet.
Due to the complexity of the Exec, individual tests will not be discussed here. Refer to the Sun
Diagnostic Executive User Manuals for additional information. Tables of Contents for the Exec are
included in this section.
Loopback connectors are required for some tests. The loopback connectors are described at the end of
this section.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/II: Trouble - Diagnostics - Diagnostic Executive
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00007/wcd0070e.htm [25.04.2002 16:00:39]