Installation manual

4800 baud 12 c0
9600 baud 25 80
Location 0x63 [Serial Port B DTR/RTS]
00 = asserts DTR and RTS signals
02 = does not assert DTR and RTS signals
Location 0x18f [LogoType]
00 = Sun
06 = 3D for CG6
12 = Custom
Location 0x492 [Password Mode Select]
Sun-3 and Sun-4 Boot PROM >= 2.7.1
5E = fully secure mode
01 = command secure mode
All else = non-secure mode
Location 0x493-0x49a [Password Bytes]
Sun-3 and Sun-4 Boot PROM >= 2.7.1
8 bytes of password in ASCII
If the PROM Rev level is 2.8, enter a @ character before each letter of the password. Enter one
letter before each location, followed by <Return>. If the password is less than 8 letters, enter
00 in the remaining locations. The hexidecimal value of the letters can also be used to enter the
password.
Location 0x60c - 0x60f [VX and MVX Options Boot Code]
31 40 00 00 = Use the VX/MVX as the system console
Location 0x610 - 0x613 [VX and MVX Options Bus Type]
FC 00 00 00 = Use the VX/MVX as the system console
References
Sun Bootstrap PROM Security Features User's Guide for the Sun Workstation, 800-8836.1.
Sun Workstation Bootstrap PROM Security Features User's Guide, 800-8843.2.
Sun-3/80 Self-Tests and Monitor Commands, 800-5027.3.
SPARCsystem 300 Series Self-Tests and Monitor Commands, 800-4950.4.
SPARCsystem 400 Series Self-Tests and Monitor Commands, 800-4833.5.
PROM User's Manual, 800-1736.6.
EEPROM Users Guide for Sun-3, Sun-4, and SPARCsystems 300/400, 800-3512.7.
Boot PROM User's Guide, 800-4852.8.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Configurations
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00004/wcd004a1.htm (5 von 5) [25.04.2002 16:24:35]