Installation manual

Table Of Contents

Jumpers

Jumpers are used to connect two pins of a Terminal Strip. Two sizes of jumpers are used: 0.100 inch

and 2.0 millimeter.

Sun PROM Monitor Commands

To program the EEPROM or NVRAM using the Sun PROM Monitor, enter q followed by the

hexadecimal address in the EEPROM or NVRAM to open and display the contents. Change the

contents by typing in the new value followed by a carriage return. To exit, type a space and <CR>, or

a "." and <CR>.

Sun4/I: Configurations

http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00004/wcd004a1.htm (2 von 5) [25.04.2002 16:24:35]