Installation manual

AC Power Sequencer
Remote and Local Bus Connectors
300-1011 / 300-1263 / 300-1264
370-1126 / 370-1127 / 370-1155 / 370-1156
Remote I/O Connectors J6, J7, J8, and J9
A parallel circuit connects J6, J7, J8, and J9. Inputs to the Remote I/O Connectors are activated by
mechanical toggle, key switch, transistor, integrated circuit, or thermoswitch with a normal open
configuration.
CONNECTOR PART NUMBER USED WITH PART NUMBER
Female
Male
AMP 1-480304-0
AMP 1-480305-0
Socket Terminals
Contact Pins
AMP 60619-1
AMP 60620-1
Cable Description
Use 3-conductor, #22 AWG stranded wire.
Remote - OFF - Local Switch
POSITION DESCRIPTION
REMOTE AC output of the Switched 1 and Switched 2 outlets is enabled
when the breaker is ON and the Power Request is connected
to Signal Return on the Remote I/O Connectors.
OFF The AC output of the Switched 1 and Switched 2 outlets is disabled.
Sun4/II: Power - AC Power Sequencer
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00006/wcd0069d.htm (1 von 2) [25.04.2002 15:59:04]