Installation manual

Power
12.1 Amps @ +5Vdc
60.5 Watts
Switch Settings
DIP SWITCH SETTING DESCRIPTION
U1601-1
U1601-2
U1601-3
U1601-4
U1601-5
U1601-6
U1601-7
U1601-8
Off
On
On
Off
On
On
On/Off
On/Off
A18 address decode
A19 address decode
A20 address decode
A21 address decode
A22 address decode
A23 address decode
Not used
Not used
Notes
The GP2 is used with the CG5 or CG9. Unbundled software is required for SunOS 3.5, 3.5.1,
3.5.2, Sys4-3.2, and Sys43.2.1. Unbundled software is not required for SunOS 4.0.
1.
The GP2 must be 501-1268-07 for use with CG9.2.
The CG9 is not supported under OpenWindows Versions 2 or 3.3.
References
Installation Notes for the GP2 and CG5 Boards, 800-2330.1.
Configuration Procedures for the GP2 and CG5 Boards, 813-2059.2.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Graphics - GP2 Graphics Processor
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd00552.htm (2 von 2) [25.04.2002 16:20:27]